Load Bearing - HP Jet Fusion 4200 Product Documentation Site Preparation Manual

Doorway specifications (continued)
Length
The processing station can be moved on the pallet up or down a ramp of no more than 10° inclination.
Unpacking and moving the processing station
You are strongly recommended to unpack the processing station where it will be used, or as close to that
location as possible.
The space required for assembly is 5.5 × 3 m (217 × 118 in).
Moving equipment
If you are using the external tank and/or material loading tank, you will need a trolley to move it.
If you need to move the processing station after unpacking, take into account the following considerations:
Ground-floor installation: The processing station can be moved on wheels up or down a ramp of no more
●
than 10° inclination.
NOTE:
Above-ground installation: Use an elevator if the processing station can fit inside it while remaining
●
horizontal (without tilting the processing station), and if it can support the processing station's weight.
Otherwise, you may need a crane; contact your reseller for more information.
CAUTION:
the risk. Move it smoothly, maintain safety precautions for people in the vicinity, and secure it against
overbalancing. Always move it parallel to its length.
CAUTION:
pallet but do not remove all the transport protections and locks.
CAUTION:
responsibility and not HP's. Failure to provide the required moving and lifting equipment could result in personal
injury or damage to the station during installation.

Load bearing

The load-bearing characteristics of the floor in the print-production area must be sufficient to withstand the
weight of your processing station. To calculate the load-bearing characteristics of the print-production floor,
consult a structural engineer.
Processing station weight
Processing station weight (loaded)
Build unit weight (full)
24 Chapter 3 Site preparation requirements for the processing station
Remove the material-cartridge platform before moving the processing station up or down a ramp.
The processing station is heavy and can easily fall over. Moving it over a ramp or tilted floor increases
If you need to move the processing station on its wheels to its final position, move it down from the
Unloading and moving the processing station and all system components is the customer's
2388 mm (94.02 in) with packaging
2283 mm (89.88 in) without packaging
470 kg (1036 lb)
1070 kg (2359 lb), including the fully loaded processing station with storage tank and
mixer, one 300 L material cartridge, and a full external tank weighing 200 kg (441 lb)
185 kg (408 lb)
ENWW