Page 2
Safety Information Thank you for purchasing this product (SWA-W500). CAUTION RISK OF ELECTRIC SHOCK. DO NOT OPEN. This symbol indicates that CAUTION: TO REDUCE THE RISK OF ELECTRIC This symbol indicates that high voltage is present SHOCK, DO NOT REMOVE THE COVER (OR BACK).
Page 3
• Route power-supply cords so that they are • Maintenance of Cabinet. not likely to be walked on or pinched by items – Before connecting other components to placed on or against them. Pay particular this product, be sure to turn them off. attention to cords at the plug end, at wall •...
Page 4
Wiring the Main Power Supply • Do not install the product in an unstable location such as a shaky self, a slanted floor, Plug (UK Only) or a location exposed to vibration. IMPORTANT NOTICE • Do not drop or strike the product. If the The mains lead on this equipment is supplied with product is damaged, disconnect the power a moulded plug incorporating a fuse.
Page 5
Precautions 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s 1. Ensure that the AC or DC power supply instructions. in your house complies with the power 8. Do not install near any heat sources such requirements listed on the identification as radiators, heat registers, stoves, or other sticker located on the rear of your product.
Page 6
– Samsung Electronics Co., Ltd reserves the right to change the specifications without notice. – Weight and dimensions are approximate. Open Source Licence Notice • To send inquiries and requests for questions regarding open sources, contact Samsung via Email (oss.request@samsung.com). Important Note About Service •...
Page 7
Connecting the SWA-W500 to a Soundbar 1. Check the standby status after plugging into an electrical outlet Plug the Wireless Subwoofer power cord into an electrical outlet and into the Wireless Subwoofer to turn on the Wireless Subwoofer. The LINK LED indicator (blue LED) on the Wireless Subwoofer blinks.
Page 8
3. Configure “ID SET” using the Soundbar’s remote control Press the Up button on the remote control for 5 seconds or press the ID SET button located at the bottom of the Soundbar. • Until pairing is complete, the Multicolour LED on the Soundbar changes as “Red → Green → Blue”...
Page 9
NOTE – If the SWA-W500 does not connect, take the necessary steps shown below according to the LED Indicator’s status. LED status Action Connected with the Soundbar Check if the power cable attached to the Blue main Soundbar unit is connected properly...
Page 10
Hereby, Samsung, declares that this equipment is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: http://www.samsung.com go to Support > Search Product Support and enter the model name. This equipment may be operated in all EU countries.
Page 11
EIRE UNITED KINGDOM EIRE This Samsung product is warranted for the period of twelve (12) months from the origi- This Samsung product is warranted for the period of twelve (12) months from the origi- beyond the control of Samsung. beyond the control of Samsung.