Transportation, Storage And Disposal; Transportation; Storage; Disposal - Husqvarna AUTOMOWER 310 Operator's Manual

7 Transportation, storage and disposal

7.1 Transportation

The supplied Li-ion batteries obey the Dangerous Goods
Legislation requirements.
• Obey all applicable national regulations.
• Obey the special requirement on package and
labels for commercial transportations, including by
third parties and forwarding agents.

7.2 Storage

• Fully charge the product. Refer to
battery on page 33 .
• Switch off the product. Refer to
product on page 33 .
• Clean the product. Refer to
page 35 .
• Keep the product in a dry, frost free space.
• Keep the product with all wheels on level ground
during storage, or use a wall hanger.
• If you keep the charging station indoors,
disconnect and remove the power supply and all
the connectors from the charging station. Put the
end of each connector wire in a connector
protection box.
Note:
If you keep the charging station outdoors,
do not disconnect the power supply and the
connectors.
• Contact Husqvarna sales representative about
what accessories are available for your product.

7.3 Disposal

• Obey the local recycling requirements and
applicable regulations.
• For questions about how to remove the battery,
refer to To remove the battery on page 47 .
7.3.1 To remove the battery
CAUTION:
Only remove the battery
when you dispose the product. When you
remove the warranty seal, the Husqvarna
warranty is no longer applicable.
1. Disconnect the product with the Main switch. Refer
To switch off the product on page 33 .
to
2. Pull out the grommet on the charging cable at the
very front of the product, and carefully remove the
connector.
3. Lift the cover, one corner at a time.
4. Remove the 14 screws with a Torx 20.
1440 - 004 - 24.03.2021
To charge the
To switch off the
5.
6.
Clean the product on
7.
8.
9.
Lift the rear edge of the top section of the chassis.
Disconnect the cable from the main circuit board.
Remove the top section of the chassis.
Remove the 2 screws that holds the battery with a
Torx 20.
Disconnect the battery cable from the main circuit
board.
Transportation, storage and
disposal - 47