Get Started; Charge The Battery; Pair The Headphones With Your - Philips 3000 Series User Manual

3 Get started

Charge the battery

Note
 Before you use your earpieces for the rst
time, place the earpieces in the charging box
and charge the battery for 2 hours for
optimum battery capacity and lifetime.
 Use only the original USB-C charging cable to
avoid any damage.
 Finish your call before charging the earpieces,
as connecting the earpieces for charging will
power the earpieces o .
Charging
Place the headphones in the charging
case and close the charging case cover.
Connect one end of the USB cable into
the charging box, and another end into
the power source.
Start charging.
• Charging process is veri ed by the
LED light on the back panel.
• When the charging box is fully
charged, the light goes o .
• When the charging box is 36% - 99%
charged, the white color light is on.
• When the charging box is 0% - 35%
charged, the amber colour light is on.
Tip
 The charging box serves as a portable backup
battery for charging the earpieces. When the
charging box is fully charged, it supports 3
times full recharge cycle for the earpieces.
 Normally, a full charge takes 2 hours (for the
earpieces or charging box) by USB cable.
 When the batter level of headset is too low,
light of headset will blink amber light
Pair the headphones
with your Bluetooth
device for the st time
Make sure that the headset is fully
charged and powered o .
Open the top cover from charging
box. The headset will power on
automatically, entering pairing
model and Right & Left headset
connected.
Light on both headsets is
blinking (white and blue)
The headset is now in pairing
mode and is ready to pair with
a Bluetooth device (e.g. a
mobile phone).
Turn on the Bluetooth function of
your Bluetooth device.

Pair the headphones with your

Bluetooth device. Refer to the user
manual of your Bluetooth device.
Note
 After powering on, if the earpieces cannot nd
any previously connected Bluetooth device, it
will automatically switch to pairing mode.