Connecting Readers - Siemens SIMATIC RF300 System Manual

Figure 1-1
1.1.4

Connecting readers

Requirement
Only wire the communication module when the supply voltage is switched off.
Required tools
When using preassembled cables, you need the following tool:
• Torque wrench set (e.g. from Peres; M12/M8, can be set; PER091) for wiring the reader
connections
Note
Using preassembled cables
When connecting the supply voltage, we recommend the cables specified in the section
"AUTOHOTSPOT" (4 x 1.5 mm
If you want to make the cable yourself, ensure that the conductor cross-section matches the
system setup or the corresponding protection (1.5 mm
When using cables that are not preassembled, you need the tool for the specific cable/connector,
for example, an insulation stripper, screwdriver or Allen wrench.
SIMATIC RF300
System Manual, xx/2020, C79000-G8976-C345-08
Connecting the grounding conductor
preassembled).
2
1.1 SIMATIC RF360R
).
2
7