Before Use - Panasonic The Advanced RF Facial Device Operating Instructions Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
WARNING
If the battery fluid leaks out and comes in contact
with the eyes, do not rub the eyes, and thoroughly
rinse with clean water, such as tap water.
‑ Failure to do so may cause eye injury.
Consult a physician immediately.
CAUTION
If the battery fluid leaks out and comes in
contact with the skin or clothes, rinse off with
clean water, such as tap water.
‑ Failure to do so may cause inflammation.

Before use

►Usage frequency
• Use this appliance up to 12 minutes total for all modes
(RF/Ultrasonic mode and RF mode) once during a day.
Use up to 3 times per week and wait at least 1 day
between each use.
Overusing the appliance will actually hurt your skin.
►Skin precautions
• Before use, perform a skin allergy test using the
conductive gel or some skin care product in place of the
gel. (See page 13.)
This quick test checks for any potential skin issues
before you begin using the appliance normally.
EH-XR10_EU.indb
11
• Please use this appliance with bare skin (after removing
make‑up and washing your face).
• Please check the condition of your skin while using this
appliance.
When having abnormal sensation on skin, stop using the
appliance immediately and consult a physician.
Skin issues can be attributable to stress, body condition,
visceral disease, skin care products, and other factors. Seek
professional medical attention if you have any skin issues.
►RF warmth level
• The ultrasonic probe increases in temperature as the RF
warmth level is increased.
Select the desired RF warmth level according to your skin
conditions and personal preferences.
When using the appliance for the first time or if any skin
discomfort occurs, you are advised to adjust the RF warmth
level to "LOW".
►Sensors
• This appliance is equipped with a sensor to detect that the
ultrasonic probe is making proper contact with the skin.
Over‑care prevention sensor: Notifies the user when the
ultrasonic probe has made contact with the skin for too long.
Fitted contact sensor: Notifies the user when the ultrasonic
probe is not in contact with the skin. (See page 16.)
►Accessories
• Before using the appliance, be sure to remove any jewellery
such as earrings on your face or around your neck.
11
2019/03/14
19:45:08

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Eh‑xr10

Table of Contents