Location Of Main Parts; Installation And Removal Of Boards - Sony DNE-1000 Maintenance Manual

2-2. BKNE-1010
2-2-1. Removal of Exterior Parts

2-2-2. Location of Main Parts

2-2-3. Installation and Removal of Boards

7. Remove the three screws, and the pad and the upper panel.
Upper panel
8. Install the pad and the upper panel in the reverse order
of the steps 1 through 7.
2-2-2. Location of Main Parts
KY-343 board
CPU-206 board
2-4(E)
2-2-3. Installation and Removal of Boards
c c c c c
To avoid shock hazards and/or damage to the mounted
PWH 3x6
circuit boards, be sure to turn off the power switch of
DNE-1000 before installing and/or removing the mounted
circuit board.
1. CPU-206 Board
(1) Remove the upper panel assembly.
(2) Remove each harness from the harness clamp. Then
Pad
Search dial assembly
Harness clamp
(Refer to the step 1 of the section 2-2-1.)
disconnect the four connectors (CN3 through CN6) on
the CPU-206 board.
CN5
CN6
CN4
Lower case
Upper panel assembly
CN3
CPU-206 board
DNE-1000