The settings are nirectly effective.
Note: The internal reference number is neleten in the following connitions:
•
after a coln start
•
after a warm start (commann line RST <CR>)
•
after entering the commann line CID <SP> / <CR>
This causes that the next transponner cone is output nefinitely.
Note: The filter function CID picks up the results of the complete reading cycles, while the parameter
NID proceens from the results of single readings! The filter function CID has effect on the serial in-
terface only.
CN – Suppression of No Reads
Through the setting CN=/ all NoRean results are suppressen on the serial interface.
Input format:
Parameter:
PARAMETER
0
/
Output (example):
--------------------------------------------------------------------------------25/39--------------------------------------------------------------------------------
CN <SP> parameter <CR>
FUNCTION
No suppression
Suppression of equal transponner numbers
0 <CR>