Nokia FastMile 4G Receiver Installation Guide
6 Reviewing safety information
6.1 Safety information for the Nokia FastMile 4G
Issue: 01
6.1 Safety information for the Nokia FastMile 4G Receiver
6.2 Available PoE injectors
Receiver
Be sure to observe the following before installing the Nokia FastMile 4G Receiver:
•
Professional installation is recommended for the Nokia FastMile 4G Receiver. If
the end-user is going to install the Nokia FastMile 4G Receiver, appropriate safety
instructions and appropriate information must be provided.
•
Only use a Nokia-approved residential gateway or a Nokia-approved PoE injector
for powering the Nokia FastMile 4G Receiver.
•
The following classes of PoE injectors are available from Nokia for use with the
FastMile 4G Receiver:
•
Class I: can comply with EN 60950-1 if grounding is provided on the wall socket;
should be put as close as possible to the place where the Ethernet cable enters the
home; see section
available from Nokia.
•
Class II: can comply with EN 60950-1 if no grounding is provided on the wall socket;
can also be used if grounding is provided on the wall socket; see section
information about the Class II PoE injectors that are available from Nokia
•
Refer to section
8.2.1
•
Do not provide power to the Nokia FastMile 4G Receiver before completing the
hardware installation steps of the installation procedure except as directed.
•
All outside wiring associated with the Nokia FastMile 4G Receiver should follow
local safety regulations.
•
Maintain at least 50 cm (20 in) distance from the front face of the Nokia FastMile
4G Receiver while the system is operating.
3TG-00387-ABBA-TCZZA
6.2
for information about the Class I PoE injectors that are
for lightning protection and other important information.
Reviewing safety information
6.2
for
31