Bosch PTL 1 Operating Instructions Manual page 12

Filling or Refilling with Water
Fill the unit with tap water only.
Never mix combustible, poisonous, caustic or
other liquids (e.g. cleaning agent) with the filling.
Filling with Water

When filling, take care that the grid over the
rubber surge protector 3 is not pressed in by
the filling container.
Refilling with Water
Take care when loosening the
tank cap.
Danger of scalding!
Procedure:
Switch off the unit.
Pull the mains plug.
Wait at least one minute.
1 609 929 984 • (04.03) T
Only then open the tank:
– Turn the tank cap lightly counter clockwise to the
first stop (position 2.).
– Allow steam to escape until no more steam is
emitted.
Press down tank cap.
– Continue to turn counter clockwise to position 3.
and remove.
3
Close the tank securely after filling:
Place on the tank cap (position 3.), press down and
tighten clockwise to the stop.
A correctly close tank cap is shown in the following il-
lustration position 1.).
When working for longer periods:
Pay attention to the minimum marking on the water
level indicator 2 and refill with water in time.
English–3
Fill with water to the maximum
marking on the water level indi-
cator 2. If the unit is filled with
warm water, the heating time is
shortened.