Advertisement
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
Output Example
LOOK ANGLE=33.1
CHAN
C/N0
SIG dB
TEMP
BEAM
STAT
BT
OC
TX
dBW
WATT
C. System Config Strapping Report
19308.354: NO SELFTEST
DATALOADER NOT CONNECTED
SYS-CONFIG='10 -- AMT-700 (HGA,SBB class 6, S64)'
19309.354: NO SELFTEST
DATALOADER NOT CONNECTED
SYS-CONFIG='10 -- AMT-700 (HGA,SBB class 6, S64)'
19310.355: NO SELFTEST
DATALOADER NOT CONNECTED
SYS-CONFIG='10 -- AMT-700 (HGA,SBB class 6, S64)'
19311.355: NO SELFTEST
DATALOADER NOT CONNECTED
SYS-CONFIG='10 -- AMT-700 (HGA,SBB class 6, S64)'
© Honeywell International Inc. Do not copy without express permission of Honeywell.
Aspire-200
Table 6-1 VT100 Scenario Report Content (Continued)
Antenna elevation angle to the satellite, with respect to the
horizontal axis of the aircraft
The channel card number
RF input Carrier-to-Noise (C/No) level; typically 50.0 to 55.0 for
Swift 64, 55.0 to 60.0 for SBB
RF input signal level—Typically -30 dB in Swift 64 and -50 dB
in SBB
HDU internal temperature
Satellite beam on which the card is registered
System call status
Boot state
Registration Status
Transmit frequency
EIRP dBw
EIRP output
The ascii digital inputs report provides information about the configuration straps
on the HDU.
To view the report, in the list of available reports, press the number next to system
config strapping.
Figure 6-2 provides an example of the ascii digital inputs report.
NO TEMPERATURE FAULT
PSU OK
OCXO READY
NO TEMPERATURE FAULT
PSU OK
OCXO READY
NO TEMPERATURE FAULT
PSU OK
OCXO READY
NO TEMPERATURE FAULT
PSU OK
OCXO READY
Description
NO CC OVERTEMP
CC ENABLED
POWER GOOD
NO CC OVERTEMP
CC ENABLED
POWER GOOD
NO CC OVERTEMP
CC ENABLED
POWER GOOD
NO CC OVERTEMP
CC ENABLED
POWER GOOD
23-15-45
Page 6-5
4 Dec 2015
Advertisement
