Fully Charge The Activeshuttle; Raising/Lowering The Loading Area Without Handheld Controller; Switching Off The Activeshuttle; Re-Commissioning After A Standstill - Bosch REXROTH ActiveShuttle 1.0 Operating Manual

44/68 Commissioning
Bosch Rexroth AG, ActiveShuttle: ActiveShuttle 1.0, 3 842 560 593/2020-07
8.3.5

Fully charge the ActiveShuttle


Fully charge the ActiveShuttle before further use (see chapter 5.3.1 Table 8).
8.3.6

Raising/lowering the loading area without handheld controller

Do not plan stopping, loading and unloading positions on, next to, or near
inclinations/slopes/gradients!
The load might tilt or start rolling when stopping, loading and unloading positions
on, next to, or near inclinations/slopes/gradients.

Do not raise or lower the loading platform in these areas.
Risk of crushing limbs when manually raising or lowering the loading area!
Limbs may be caught and crushed between the loading area and the dolly or
between the fl oor and casters of the dolly during manual raising or lowering of the
loading area.

Make sure that no limbs are in the hazard zone when raising or lowering the
loading platform.

Press and hold the activation key (O) for more than 3 s.
Loading area in lower position
Loading area in upper position
8.3.7

Switching off the ActiveShuttle

1. Press the ON/OFF button (N) for 5 seconds.

The ON/OFF button (N) fl ashes green.

The activation key (O) fl ashes green.

The ActiveShuttle switches off.

8.4 Re-commissioning after a standstill

Follow the steps for initial commissioning and the instructions in the ActiveShuttle
Management System (AMS).
CAUTION

Loading area lifts

Loading area lowers