Logitech Alert 700n Getting Started

Getting started with
Logitech Alert 700n
™
®
Add-On Camera
1
Run Logitech Alert
Commander
Before you begin the installation, read
all instructions.
!
Logitech Alert Master System required.
1) Be sure that Logitech Alert Commander
sotware is running on the PC before
beginning installation of camera.
Using In-the-box Accessories
You can use the mini-suction cup and
cable wall clips to help route the power
supply cable (yellow connector) along
the window's edge and provide addi-
tional security to that camera.
1 2
6
5
1 Logitech Alert Camera
2 Camera power supply
3 Power supply cable (yellow tips)
4 Mounting accessories
PC
2
Plug in Your Camera
When prompted to connect your camera:
1) Remove the hatch from the back of the camera. 1a) Plug the yellow
cable connector into the port.
1b) Use the lock slider to lock the connector in place.
1
1a
1b
• Shortly after connecting, your camera will appear in Alert Commander software. You can now move the camera to its
desired location.
Wall/Ceiling Mounting Instructions
!
Warning
Using camera to look out
The wall mount allows you to easily
a window fasten your camera to a ceiling or
wall. 1) Start by pre-drilling holes
Only use for non-night vision applications
into the wall and screwing in the
or when a secondary outdoor lighting
mounting base.
source is available. Infrared illumination
used in night vision cameras cannot
penetrate glass and can adversely a ect
picture quality.
You can turn o night vision in the Settings
> Camera> Advanced>Night Vision O
3
7 8
5 Suction cup
6 Desktop stand
7 Cable extender
8 System Requirements Guide
2) Plug the yellow cable into the power supply port.
2a) Plug the power supply into an outlet near the PC where
the software is installed.
2
2a) Thread the ball joint into the camera. 2b) Place the ball
joint end into the wall mount clamp and tighten, using the
wing nut.
2a
1
4
!
Legal Warning
Certain uses of security camera
products and audio devices,
such as employee monitoring,
surreptitious viewing and
Network Adapter / Power Supply Install Note
recording of images and/or
audio, or the use, publication or
distribution of image and/or
Caution should be used when plugging the Logitech Alert
audio recordings, are prohibited
network adapter or camera power supply into a surge
or restricted by country, state
protector, power strip, extension cord or UPS (un-interuptable
and local laws.
power supply) because they may filter, interfere with or even
block signal transmission. To eliminate any potential issues we
Be sure to comply with the laws
recommend plugging the network adapter or power supply
in your country, state, and
directly into your wall outlet.
locality when using Logitech
Alert products and services. Note: Logitech Alert network adapters and power supplies have
their own built-in surge protectors.
3
Choose Your Camera Location
2a
On a desk or table
3) Attach the camera to the mounting arm.
3
2b
mounting arm (optional)
!
On a window looking in
Clean the window's surface and the inside area
of the suction cup before applying it to the
window. Periodically press the suction cup
against the glass to strengthen its bond to the
window.
OR