AEG BSS 4807 Instruction Manual page 65

2. Press the button (11). The hours will start to flash.
3. Set the hours using the
4. Press the button again. The minutes will start to flash.
5. Set the minutes using the
6. Press the button once more in order to save the time.
NOTE:
If the battery is completely empty, the time must be reset.
Radio mode
1. Press the "M" button (12) repeatedly until "FM" is shown on the display.
2. Automatically search for radio stations:
Keep the 10+/CH- button (7) or the 100+/CH+ button (8) pressed for approx.
2 seconds. The unit scans the complete frequency band for stations. The radio stations
found are stored in ascending order of frequency. The sequence cannot be altered
later.
NOTE:
Any preset radio stations will be overwritten.
To look for a radio station manually and preset it:
a) Select the channel location where you want to preset the station. You can select a
channel location by briefly pressing the 10+/CH- button (7) or the 100+/CH+ but-
ton (8).
b) Briefly press the /SEEK+ / /SEEK- button (9/10), until you have found the radio
station which you are looking for. If you keep the button pressed, the device will
keep searching up to the next and/or previous radio station.
c) Keep the button (11) pressed until the channel location is shown. The radio
station is now preset.
3. The aerial is built into the device. If the reception is too weak and the station that has
been tuned into has interference, try changing the position of the device in order to
improve the reception.
Select the preset radio station
Briefly press the 10+/CH- and/or the 100+/CH+ button (7/8) in order to select the preset
radio station.
/SEEK+ / /SEEK- buttons (9/10).
/SEEK+ / /SEEK- button.
English
65