7
Installing the Cutting Units
Parts needed for this procedure:
1
Gauge bar
Cutting unit (obtain from your authorized Toro
3
Distributor)
3
Grass basket
3
Electric-reel-motor counterweight
6
Capscrew
Procedure
1.
Setup the cutting units as described in the
cutting unit Operator's Manual.
2.
Apply grease to the inside diameter of the drive
coupler.
3.
Install the electric-reel-motor counterweight
as described in
Installing the Electrical
Counterweights (page
4.
Install the cutting units as described in
the Cutting Units (page
8
Setting the Clip-Control
Feature
No Parts Required
Procedure
To achieve a consistent, high quality-of-cut and a
uniform after cut appearance, the machine has a
clip-control feature that varies the speed of the reels
with the speed of the machine, to maintain a constant
clip. This feature is O
FF
turn it O
, refer to
Setting the Clip-Control Feature
N
(page 22)
32).
Installing
32).
by default; to configure it and
9
Adding Rear Weight
Parts needed for this procedure:
1
Weight kit – Part No. 119-7129 (purchase separately)
Procedure
This unit complies with the ANSI B71.4-2012 and EN
ISO 5395:2013 Standards when equipped with the
Weight Kit (Part No. 119-7129).
10
Installing the CE Guard Kit
Parts needed for this procedure:
1
CE Guard Kit―Part No. 04443 (sold separately)
Procedure
Install the CE guard kit; refer to the CE Guard Kit for
Greensmaster 3420 TriFlex Traction Unit Installation
Instructions.
11
Installing EU Decals
Parts needed for this procedure:
1
Warning decal 133-2339
Procedure
If this machine will be used in the EU, affix the warning
decal 133-2339 over warning decal 133-2338.
17