Installing The Latch Lock - Toro ProCore SR54 Operator's Manual

1. Bolts
2. Lock washer
3. Remove the storage stands.
4. Use the storage stands whenever you remove
the aerator from the traction unit.
Preparing Model SR72
1. Raise the aerator roller(s) 7.5 to 15 cm (3 to 6
inches) off the ground. Place support blocks
under the roller(s).
2. Remove the bolts, lock washers, and nuts
securing the storage stands to each end of the
aerator (Figure 34).
1. Bolts
2. Lock washer
3. Remove the storage stands.
4. Use the storage stands whenever you remove
the aerator from the traction unit.
Note:
When installing the storage stands,
ensure that the stands mount to the inside of the
roller plates so that the lower frame tube rests
on the top of the stands.
Figure 33
3. Nut
4. Storage stand
Figure 34
3. Nut
4. Storage stand
Note:
Models SR54-S and SR70-S do not have
storage stands.
17

Installing the Latch Lock

CE Only
Parts needed for this procedure:
g010857
2 Lock plate
2 Tap bolt
2 Retaining ring
Procedure
1. Position the latch plate over the hood latch while
aligning the mounting hole with the hole in the
side plate
g010967
1. Retaining ring
2. Mounting hole
2. Secure the latch plate to the side plate with a tap
bolt and a retaining ring
3. Repeat the procedure on the other hood latch.
20
(Figure 35).
Figure 35
3. Latch plate
4. Tap bolt
(Figure 35).
g016161