Mfm Board - Samsung iDCS 500 Manual
Printed circuit cards
Hide thumbs
Also See for iDCS 500:
- Programming manual (533 pages) ,
- User instruction (140 pages) ,
- Technical manual (137 pages)
Advertisement
SCM BOARD
This board has selectable options and installs in any
available position of the MCP card when the system
has one cabinet installed
has more than one cabinet the SCP board may be
installed in any available position of the SCP card
. Only one SCM board can be installed in a
Figure 3-3)
system (on the MCP or SCP). The SCM board is
used to increase the number of available conference
circuits by 5 party 18 groups and to add 12 DSP
circuits for DTMF and tone detection. To install the
SCM board remove the two (2) screws holding the
MCP protective casing together
remove the 4 screws holding the SCP case together
(see Figure 3-10)
Place the SCM board face down over the two
connectors, taking care to properly line them up and
press gently on the back of the board to seat it. The
MCP/SCP case can now be reassembled if all
required daughter boards have been installed.
NOTE: Only one SCM board can be installed per system. SCM card cannot be installed with a MFM
card on the same processor card.
MFM BOARD
This board has no selectable options and installs in
any available position of the MCP card when the
system has one cabinet installed
system has more than one cabinet the MFM board
must be installed in position LOC3 of the MCP card,
any available position of the SCP card
or any available position of the LCP cards. Up to 3
MFM board can be installed in a system (one on the
MCP or SCP and one on each LCP). The MFM board
is used to provide an additional 12 DSP circuits for
DTMF and tone detection. To install the MFM board
remove the two (2) screws holding the MCP or LCP
protective casing together
4 screws holding the SCP case together
and separate the two halves of the case. Place the
MFM board face down over the two connectors,
taking care to properly line them up and press gently
on the back of the board to seat it. The
MCP/LCP/SCP case can now be reassembled if all
required daughter boards have been installed.
NOTE: Only one MFM board can be installed on each processor card. A MFM card cannot be installed
onto a processor card with an SCM card installed.
. If the system
(see Figure 3-1)
(see Figure 3-6)
and separate the two halves of the case.
(see Figure 3-1)
(see Figure 3–3)
(see Figure 3-6)
(see
or
. If the
or remove the
(see Figure 3-10)
Figure 3-11 SCM Board
Figure 3-12
MFM Board
3-13
Advertisement
