TPA 300 USAGE IN STANDALONE MODE
TPA 300 Standalone mode is used to read, program and copy TPMS sensors, test
RKE, save and read recorded jobs, and setup the tool. If you need to register the
TPMS sensor IDs into the vehicle ECU you must use the TPA 300 Connect to scan
tool mode. See this user manual dedicated section to learn how to operate this
mode.
SELECT STANDALONE MODE
1. CHECK TPMS SENSORS
This mode is to trigger all the TPMS sensors on the vehicle.
Warning! For best sensor triggering, hold the tool
against the tire sidewall right above the sensor.
1.1. S
C
ELECT
AR
UM-BTPA1-6
IMPORTANT:
M
ANUFACTURER
9/54
TPA 300 user guide
= Continue
= Continue
= Previous
User guide BOSCH TPA 300