Documenting Measurements; Data Transmission - Bosch GTC 400 C Operating/Safety Instructions Manual

are pressed. You can also deactivate the
automatic switch-off by selecting the
"Never" setting.
– "Delete all images"
Under this menu item, you can delete all
the files in the internal memory at once.
Press the right-hand arrow button 8 for
"more ..." to enter the submenu. Then
press either the left-hand function button
13 under the tick symbol to delete all files,
or the right-hand function button 7 under
the cross symbol to cancel the operation.
– "Tool information"
Under this menu item, you can access
information about the tool. There you can
find the serial number of the tool and the
installed software version.
You can also press button 17 to exit any menu
and return to the standard display screen.

Documenting measurements

Saving measurements
The tool begins to take measurements as soon
as it is switched on and does so continuously
until it is switched off.
To save an image, point the camera at the
desired measuring object and press the
"Save" button 11. The image is saved in the
camera's internal memory. Alternatively,
press the "Freeze measurement" button 17.
The measurement is frozen and shown in the
display. This enables you to take as much time
as you need to look at the image. If you do not
wish to save the frozen image, press button
17 to return to measuring mode. If you wish
to save the image in the camera's internal
memory, press the "Save" button 11.
Calling up saved images
Proceed as follows to call up saved thermal
images:
– Press the left-hand function button 13. The
most recently saved photo now appears in
the display.
– Press the right-hand 8 or left-hand 12 arrow
button to switch between the saved thermal
images.
Deleting saved images
Go to the gallery view to delete individual
thermal images:
– Press the right-hand function button 7 under
the waste paper basket symbol.
– Confirm the operation by pressing the left-
hand function button 13 or terminate the
deletion process by pressing the right-hand
function button 7 under the cancel symbol.
Delete all images
In the "Delete all images" menu, you can
delete all the files in the internal memory at
once.
Press the "Func" 6 button to call up the
measuring functions. Now press the right-hand
function button 7 and select "Tool" > "Delete
all images". Press the right-hand arrow button
8 to enter the submenu. Then press either the
lefthand function button 13 under the tick
symbol to delete all files, or the right-hand
function button 7 under the cross symbol to
cancel the operation.

Data Transmission

Data Transmission via USB Interface
Open the cover on the micro USB port 3.
Connect the micro USB port on the tool to
your PC or laptop using the micro USB cable
provided.
Now press button 9 to switch on the thermal
imaging camera.
Open the file browser and select the "BOSCH
GTC 400 C" drive. The saved JPG files can be
copied, moved to your computer or deleted
from the internal memory of the tool.
As soon as you have ended the required
operation, disconnect the drive following the
standard procedure and then use button 9 to
switch the thermal imaging camera off again.
Remove the micro USB cable during the
measurement operation and close the cover 3.
Attention: Always disconnect the drive from
your operating system first (eject drive), as
failure to do so may damage the thermal
imaging camera's internal memory.
Always keep the cover of the USB interface
closed so that dust and splashes cannot enter
the housing.
-16-