Miele WTS 510 Fitting Instructions Manual page 36

36 von 86
DANGER
There is a risk of injury, particularly spinal injuries, as the machine must be placed on its side for installation.
A
The relation of the weight of the machine to the physical strength of the technician must be taken into account.
For machine weight details, see the operating instructions.
Risk of injury due to incorrect installation
WARNING
Risk of accident if machine tips over.
A
The stand may only be used with Miele machines.
A
The stand must not be used with integrated models or a washer-dryer stack combination.
A
Fasten the washing machine to the stand.
A
When combining with one or more other stands, individual stands must be connected together with the
connection pieces.
A
With a single machine installation, secure the stand to the floor with the floor fastening kit, mat. no. 06593051.
A
At least two stand feet must be bolted to the floor and at least one of these should be at the rear. Fastening of
two diagonally opposite feet is ideal.
Danger due to unsuitable materials in the stand drawer
DANGER
A
Do not store any inflammable items in the drawer.
NOTE
Wooden parts may swell and/or warp.
A
Do not store any damp or wet items in the drawer.
Stand installation
Removing the drawer from the stand
A
Pull the drawer all the way out; see Fig. 2.
A
Press the spring catches while lifting the drawer upward; see Fig. 3.
Installing the stand under a dryer
A
Empty the condensate container.
A
Screw the dryer feet in fully with a pipe wrench.
A
Remove the set screws from the stand with a 5 mm Allen key (A); see Fig. 4. These set screws will no longer be
needed.
A
Install the supplied 10 x 40 mm set screws as far as possible into the threaded bolts (B); see Fig. 4.
WARNING
Risk of crushing fingers if they are trapped between the dryer casing and the set screws.
A
Do not lift the dryer at the corners.
A
Lift the dryer onto the stand and guide the set screws into the openings in the dryer feet; see Fig. 5.
A
Install the sealing strips as shown on the inside of the rear panel; see Fig. 6.
A
Loosen the screws on the eccentric cams (1) on the dryer rear panel; see Fig. 7
28.09.2018 Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
M.-Nr. 09469886