Main Board Block-1 - Sony SRS-ZR7 Service Manual

2-7.

MAIN BOARD BLOCK-1

• Continued on 2-8 (page 16).
right side
sheet (A)
coaxial harness [black]
Note: Lay a soft piece of cloth under the unit
to avoid damaging the top panel.
5 three screws
5 screw
(BTTP M2.6
(BTTP M2.6 8)
connection cable
(GND strap)
5 screw
(BTTP M2.6 8)
– –
coaxial harness [gray]
4 four sheets (A)
8)
6 Take out the coaxial
harness [black] outward.
5 screw
(BTTP M2.6
connection cable (GND strap)
rib
screw hole
6 Take out the coaxial
harness [gray] outward.
1 sheet
(BOTTOM FFC)
2 flexible flat cable
(4 pin) (CN208)
This side is the
terminal side.
1 sheet (A)
front side
8)
5 two screws
(BTTP M2.6 8)
coaxial harness [gray]
rib Do not pass the wire into
the screw hole.
SRS-ZR7
sheet (BOTTOM FFC)
sheet (A)
The opposite side is
the terminal side.
3 flexible flat cable
(24 pin) (CN207)
bottom side
front side
Ver. 1.3
15