Troubleshooting - Husqvarna 122C Operator's Manual

2. Clean the air filter with warm soap water. Make sure
that the air filter is dry before you install it.
3. Replace the air filter if it is too dirty to fully clean it.
Always replace a damaged air filter.
4. If your product has a foam air filter, apply air filter oil.
Only apply air filter oil to a foam filter. Do not apply
oil to a felt filter.
To apply air filter oil to the air filter
CAUTION: Always use special air filter oil on
foam air filters. Do not use other types of oil.
WARNING: Do not get oil on your body.
1. Remove the air filter cover and remove the air filter.
The engine does not start
Check
Starter pawls.
Fuel tank.
16

Troubleshooting

Possible cause
The starter pawls cannot move freely.
Incorrect fuel type.
2. Put the air filter in a plastic bag.
3. Put the air filter oil in the plastic bag.
4. Push the plastic bag to make sure the oil supplies
equally across the air filter.
5. Push on the air filter, while in the bag, to remove the
air filter oil that is not necessary. Remove the air
filter from the bag.
6. Install the air filter.
To add grease to the bevel gear
• Make sure that the bevel gear is filled ¾ full with
bevel gear grease.
Procedure
Remove the starter cover and clean around
the starter pawls.
Let an approved servicing dealer help you.
Drain the fuel tank and fill with correct fuel.
941 - 005 - 22.09.2020