Controlling A Tv With The Remote; Connecting Your System To The Power Supply; Before Using The Dvd Player - Samsung HT-DM140 Instruction Manual

Controlling a TV with the Remote

You can operate your TV by adjusting the DVD remote signal.
1
Turn on the TV.
2
Point the DVD's remote at the TV.
TV
3
While holding the button down, enter the
code for your brand.
•
If there is more than one code listed in the table,
enter one at a time to determine which code works.
example : For SAMSUNG 1TVs TV
While holding down the
enter .
4
If the TV turns off, setup is complete.
•
Now, you can perform the following operations on the TV.
TV : Turn on or off the TV.
VOLUME +/– : Adjust the volume.
TV/VIDEO : Set the input mode (either TV or VIDEO)
CHANNEL +/– : Change the channels.
•
Manufacturers' codes are subject to change without notice. If they are changed, this
remote control cannot operate the equipment.

Connecting your System to the Power Supply

The AC Cord must be plugged into an appropriate socket.
Before plugging your system into an AC outlet, you must check the voltage.
1. Plug the AC Cord on the rear of the system into an appropriate outlet.
2. Press the On/Standby button to switch your DVD Player system on.
13
Manufacturer CODES
Samsung 01~06,32
Akai 12
FIisher 12
Grundig 09,17,21
Hitachi 11,13,14,24
JVC 32
LG 02,30
Mitsubishi 02,16
Mival 29
Nokia 23
Nordmende 13,14,24
button,
Panasonic 08,23~27
Philips 02,20,22
Saba 13,14,22~24
Sanyo 12,16
Schneider 02
Sharp 10,31
Sony 15,16
Telefunken 14,24,28
Thomson 13,14,24,33,34
Toshiba 07,16~19,21
AV OUT
RGB
COMPOSITE

Before Using the DVD Player

Your DVD player is capable of playing DVD, VCD, and CD discs.
User instructions may vary depending on the type of disc. Read the instructions
carefully before use.
1
Turn on the power Select a video mode by
to your DVD player pressing the TV/VIDEO
Prepe-
and TV. button.
rations
before
TV
use
•
The "WAIT" message that appears on the display for about 4~5 seconds when turning on the
power or selecting a DVD function indicates a stabilization period for optimizing the condition of
your DVD player. While the message is being displayed, other buttons remain inactive.
•
When the power is not turned on, press down the Stop (
seconds.
The product will be initialized to its optimum state.
•
Some operational features such as the Speaker mode, Test tone, Volume, etc. will not be
displayed on the TV screen.
TV Broadcast System
• This device is designed to work with the PAL video format.
• For normal playback, the video format a DVD disc is recorded in must
coincide with your TV's video format.
2 3
Press the DVD button
to select the DVD input
function.
TV/VIDEO
DVD
) button on the main unit for over 5
14