Toshiba BC Series Instruction Manual page 73

● Control procedure
■ On /Off of DPC function
Set value to DPCEnable register.
■ Set the coordinates of defective pixels.
Sets the number of pixels to correct to 'DPCNumber'.
The defective pixels are corrected by calculation from the neighboring pixels by setting to coordinate to
'DPCValue' register. If defective pixel exists plural number, these defective pixels are corrected by set
coordinate to another 'DPCValue' register.
Copyright © 2019 Toshiba Teli Corporation, All Rights Reserved.
Setting
OFF
ON (*)
DPCNumber
Minimum 0
Maximum 256
Function
Disable
Enable
* initial factory setting
DPCValue[X] DPCValue[Y]
0
WidthMax-1 HeightMax-1
71 / 73
0
D4296087A
http://www.toshiba-teli.co.jp/en/