Hitachi YUTAKI S Series Technical Catalogue page 127

9 Electrical and control settings
Setting of DIP switches and RSW switches
9.6.1.3 LED indication
Name Colour
LED1 Red
LED2 Green
LED3 Yellow
LED4 Yellow
LED351 Red
LED353 Red
LD1 Red
LD2 Red
LD3 Red
LD4 Red
9.6.2 YUTAKI unit
9.6.2.1 Location of DIP switches and rotary switches
9.6.2.2 Function of DIP switches and rotary switches
?
N O T E
• The mark "■" indicates the dip switches positions.
• No mark "■" indicates pin position is not affected.
• The figures show the settings before shipment or after selection.
• "Not used" means that the pin must not be changed. A malfunction might occur if changed.
!
C A U T I O N
Before setting dip switches, first turn the power supply OFF and then set the position of dip switches. If the switches are set without turning
the power supply OFF, the contents of the setting are invalid.
119 TCGB0123 rev.2 - 10/2019
Indication
PCB1
Power
Communication with inverter
H-Link transmission
Not used
For inspection
For inspection
PCB2
For inspection
For inspection
For inspection
For inspection
9