Mitsubishi Electric RP-1ADH-S15 Series Standard Specifications Manual page 69

■ Key layout and main functions
①
⑤
⑥
⑦
⑨
⑪
⑫
⑬
⑭
⑮
⑯
⑳
1) : [Emergency stop] switch............... The robot servo turns OFF and the operation stops immediately.
2) : [Enable/Disable] switch................. This switch changes the T/B key operation between enable and dis -
3) : [Enable] switch .................................. When the [Enable/Disable] switch "2)" is enabled, and this key is
4) : LCD display panel............................. The robot status and various menus are displayed.
5) : Status display lamp.......................... Display the state of the robot or T/B.
6) : [F1], [F2], [F3], [F4] ........................ Execute the function corresponding to each function currently dis -
7) : [FUNCTION] ....................................... Change the function display of LCD.
8) : [STOP] key ......................................... This stops the program and decelerates the robot to a stop.
9) : [OVRD ↑ ][OVRD ↓ ] key.......... Change moving speed. Speed goes up by [OVRD ↑ ] key. Speed goes
10) : JOG operation key ........................ Move the robot according to jog mode. And, input the numerical value.
11) : [SERVO] key.................................... Press this key with holding AA key lightly, then servo power will turn
12) : [MONITOR] key .............................. It becomes monitor mode and display the monitor menu.
13) : [JOG] key.......................................... It becomes jog mode and display the jog operation.
14) : [HAND] key....................................... It becomes hand mode and display the hand operation.
15) : [CHAR] key....................................... This changes the edit screen, and changes between numbers and
16) : [RESET] key..................................... This resets the error. The program reset will execute, if this key and
17) : [ ↑ ][ ↓ ][ ← ][ → ] key............ Moves the cursor each direction .
18) : [CLEAR] key .................................... Erase the one character on the cursor position .
19) : [EXE] key........................................... Input operation is fixed. And, while pressing this key, the robot moves
20) : Number/Character key................ Erase the one character on the cursor position . And, inputs the num -
Fig.3-19 ： Teaching pendant key layout and main functions
④
⑤
⑥
⑧
⑩
⑰
⑱
⑲
able.
released or pressed with force, the servo will turn OFF, and the oper -
ating robot will stop immediately.
played on LCD.
down by [OVRD ↓ ] key
on.
alphabetic characters.
the EXE key are pressed.
when direct mode.
ber or character
3 Controller
②
③
Teaching pendant (T/B) 3-60