Bosch Professional GTA 60 W Original Instructions Manual page 15

OBJ_BUCH-857-003.book Page 15 Thursday, January 29, 2009 10:22 AM
Assembly
Delivery Scope
Please also observe the represen-
tation of the delivery scope at the
beginning of the operating instruc-
tions.
Before assembling the saw stand, check if all
parts listed below are provided:
No. Designation
1 Mounting plate
6 Upper frame with lock 2
7 Bottom frame
8 Wheel with linkage bar 9
10 Foot lever
11 Fastening kit
consisting of:
– Hexagon bolt
M10 x 100
M10 x 50
M6 x 110
M6 x 75
M6 x 40
– Phillips screw
M8 x 50
– Washer
M10
M10 (clamping washer)
M6
– Lock nut
M10
M8
M6
Additionally required tools (not in delivery
scope):
– Phillips screwdriver
– Open-end spanner (10 mm, 8 mm, 6 mm)
Bosch Power Tools
Assembling the Mobile Stand Base
– Carefully remove all parts included in the de-
livery from their packaging.
– Remove all packaging material.
– For assembly, follow figures A – E. Also ob-
serve the following notes.
For Fig. A:
– Bolt the upper frame 6 and the bottom frame
7 together.
Quantity
For Fig. B:
1
– Screw both the left and right wheel 8 to the
1
upper frame 6.
1
Pay attention that the linkage bars 9 face out-
ward and that the tires of the wheels face to-
2
ward the bottom frame 7.
1
Note: Do not over-tighten the nuts. Parts bolted
together must move freely.
For Fig. C:
6
– Bolt the foot lever 10 to both wheels 8.
2
4
For Fig. D:
4
– Screw the mounting plate 1 on both sides to
4
the upper frame 6.
Note: Do not over-tighten the nuts. Parts bolted
6
together must move freely.
18
For Fig. E:
2
– Bolt the left and right linkage bar 9 each to
8
the mounting plate 1.
6
Note: Do not over-tighten the nuts. Parts bolted
6
together must move freely.
4
English | 15
1 609 929 S18 | (29/1/09)