Husqvarna 322HD60 Operator's Manual page 8

CAUTION: Small errors can influence the
ratio of the mixture drastically when you mix
small quantities of fuel. Measure the quantity
of oil carefully and make sure that you get
the correct mixture.
1. Fill half the quantity of gasoline in a clean container
for fuel.
2. Add the full quantity of oil.
3. Shake the fuel mixture.
4. Add the remaining quantity of gasoline to the
container.
5. Carefully shake the fuel mixture.
CAUTION: Do not mix fuel for more than 1
month at a time.
To fill the fuel tank
1. Clean the area around the fuel tank cap.
2. Shake the container and make sure that the fuel is
fully mixed.
3. Tighten the fuel tank cap carefully.
4. Move the product 3 m/10 ft or more away from the
refueling area and fuel source before starting.
Note: To see where the fuel tank is on your product,
Introduction on page 2 .
refer to
To adjust the handle
The rear handle can be adjusted into 3 positions.
8
• Release the handle lock and turn the handle.
To start the product with a cold engine
1. Pull the choke control to choke position.
2. Push the air purge bulb approximately 6 times or
until the bulb starts to fill with fuel. It is not necessary
to fill the air purge bulb fully.
3. Hold the body of the product on the ground with your
left hand. Do not step on the product.
4. Pull the starter rope handle slowly with your right
hand until you feel some resistance, then pull the
starter rope handle quickly and with force.
WARNING: Do not wind the starter rope
around your hand.
CAUTION: Do not pull the starter rope to
full extension and do not let go of the
starter rope handle.
5. Continue to pull the starter rope handle until the
engine fires, then push the choke control to its initial
position.
WARNING: The blades move when the
engine starts.
6. Continue to pull the starter rope handle until the
engine starts.
1073 - 004 -