Haier ES30V-A3 Instruction Manual page 19

Installation
Installation instruction
Hot water
pipe
nozzle
Note: Category of power line plugs in schematic diagram is only used for sketch.
Installation Method
Must be installed by personnel in our company's After-sales Department or designated
installation personnel.
The water heater is wall-mounted type.
Determine the installation position of the water heater. Based
on the measurements indicated in the technical data form,
use impact drill to drill two holes of 12mm in diameter and
65mm in depth. Insert the expandable hooks into the said
holes and ensure that they are securely fixed. Lift the water
heater and slip its wall hook onto the expandable hooks. For
accessories such as safety valve, please refer to the
"Installation of Safety Valve" (for reference only). Make sure
to seal the joints with Teflon tapes to prevent water leakage.
For ease of installation and removal of water heater, we would recommend that G1/2
loose joints be installed at appropriate locations on the water inlet and outlet pipes of the
water heater. Determine the position of the hot water supply. Connect the water intake
and outlet pipe together with the water pipe to the positions reserved for use of hot water.
Hot water pipe should preferably not be too long in order to prevent heat loss.
Note: Make sure that the water heater is securely attached to the hook before letting it go;
otherwise it may drop and cause injury or property damage.
℃
Hot water
Cold water pipe
outlet
Safety valve
Water temperature indicator
Direction of cold water
Direction of hot water
Cold water inlet
7
℃
Wall-mount
Expandable
support
hook