Yamaha MLC-200 Installation Manual page 19

9. Installing onto an instrument (optional) — continued
9-2. While holding the MLA-200 in the desired position, drill four holes
(for attaching the mounting bracket) into the instrument's stand (leg).
Drill holes with a depth of 15 mm and diameter of 2.5 mm at the center of the screw holes, positioned at least
15 mm inside the edge of the stand (leg). Be careful not to drill the holes too deep. In addition, be sure to drill all
four holes.
NOTE
If the exterior of the instrument has a polished (mirror) finish,
also countersink the holes to about 6 to 6.5 mm in diameter.
6 to 6.5 mm
2.5 mm
9-3. Drive in the center screw about halfway.
9-4. Hook the guide hole at the center of the mounting bracket onto the
center screw.
15 mm
MLC-200 Installation Guide – 19