ABB IRC5 Applications Manual page 73

Fault indication
If there is a problem with a device, like duplicated IP address, the device will be
marked red.
en1100000261
Device identification
Sometimes it is difficult to distinguish devices in the network from each other. A
useful function in such a case is the Flashing On functionality. This will send a
request to the selected device to flash its status LEDs.
1
2
3
Limitations
Since the gateway is chosen from IP Route and must be valid to our system it is
not possible to set the gateway externally from DCP request, ie.
AddressAssignMode is LOCAL when it comes to the gateway parameter.
Application manual - PROFINET Controller/Device
3HAC050969-001 Revision: G
Action
Select a device from the list and click the Flashing On button.
The status LED on the selected device will start to flash.
Click the Flashing On button again to stop the status LED from flashing.
© Copyright 2015-2018 ABB. All rights reserved.
A About the third party tool information
Continued
73