Sealey SD400K Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE
PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL
INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this equipment,

make sure you know where the nearest fire extinguisher is.
WARNING! Always wear approved eye / face protection when operating the torch.

WARNING! DO NOT use the torch if you notice that it is damaged or if there could be a gas leak from it.

WARNING! Butane gas is extremely flammable, handle with care.

WARNING! Always point the torch away from the eyes and body when igniting and during operation.

WARNING! DO NOT put the torch down when it is lit, DO NOT leave it unattended.

WARNING! The flame is not easily visible in bright daylight.

WARNING! Ensure the flame is completely extinguished after use. DO NOT use water to cool the torch down.

WARNING! Only use in a well ventilated area.

DO NOT use the torch in an area where paint fumes, solvents or other flammable solids, liquids or gases pose a potential hazard. Keep

flammable material away from the torch when operating.
DO NOT operate the torch when you are tired or under the influence of alcohol, drugs or intoxicating medication.

DO NOT hold any workpiece by hand.

DO NOT touch the workpiece close to the heated area as it will be very hot. Allow to cool.

DO NOT operate the torch if it is damaged as this may cause failure and/or possible personal injury.

DO NOT touch the top of the torch during or immediately after use, as it will be very hot. Allow to cool.

DO NOT allow children to operate the torch.

After use, allow the torch to cool before storing it.

When not in use, store away from direct sunlight in a safe, dry, childproof location.

DO NOT store at over 40°C, such as in a car in hot weather.

2. INTRODUCTION
Comprehensive soldering/heating kit ideal for any handyman, enthusiast or electrician. This kit includes a variety of necessary tools and
accessories for a range of applications. Features a high powered soldering, heating and shrinking torch with piezoelectric ignition. Also included is a
pack of varied size heat shrinks and high quality electrical shears. Supplied in a heavy-duty BMC case.
3. CONTENTS
Soldering torch
Hot Air Nozzle
Deflector Nozzle
3 x Tips
Hot Knife
© Jack Sealey Limited
INSTRUCTIONS FOR:
SOLDERING KIT
SD400K
MODEL No:
115mm Side Cutters
Electrical Shears
3mm Desoldering Braid
Wire Stripper/Cutter/Crimper with Wire Guide
Heat Shrink Pack: 1.5, 2.5, 3, 5, 6mm
Original Language Version
SD400K Issue: 1 - 02/09/14