Yamaha 485RDS Owner's Manual page 18

Calling a preset RDS station by the station name (PS SEEK)
You can call a desired RDS station stored in this unit by only inputting the name of the station in the PS mode. By this operation,
this unit searches all preset stations for the station. You do not have to input a full name, even only the first letter can be used for
calling. As many as 8 letters and/or numerals can be selected for inputting a name.
1
FM/AM
2
Turn the unit into the PS mode.
PS/PTY SEEK
FREQ/PS/PTY SHIFT ENTER
* If "NO PS" flashes, proceed to the next step while flashing.
If "NO PS" disappears before you proceed to the next step,
press the FREQ/PS/PTY button again.
3
PS/PTY SEEK
FREQ/PS/PTY SHIFT ENTER
4
Select the first letter or numeral of the station name.
TUNING
DOWN UP
* By pressing the TUNING button repeatedly or by pressing
and holding it, the display will change letters and numerals
in sequence.
* If you will not input the second letter, skip to step 7.
5
When the first letter or numeral of the station name
appears, press the SHIFT button to proceed to the
selection of the next letter or numeral.
PS/PTY SEEK
FREQ/PS/PTY SHIFT ENTER
18
4 8
1
FM
A station name
is displayed or
"NO PS" flashes.
Flashes.
"A" will flash on the second
letter or numeral position.
2, 3, 5, 7
6
Repeat steps 4 and 5 for other letters and/or numerals,
if necessary.
7
When inputting the name is finished, press the ENTER
button.
PS/PTY SEEK
FREQ/PS/PTY SHIFT ENTER
8
PRESET
STATIONS
DOWN UP
The unit begins searching for the station, and it is
continued until the station is found.
You do not have to input a full name for searching
for the station
You may input only the first letter of the station name. If doing
so, you can skip steps 5 and 6. In step 8, the unit searches
for and calls a nearest station which has the letter you input. If
the station is not the desired one, press the PRESET
STATIONS button again. The unit will begin searching for
another station which has the same letter.
To cancel this function
Press the AF, FREQ/PS/PTY, SHIFT, ENTER, FM/AM or
MEMORY button.
Notes
If no station is found by this function after searching all
preset stations, "NO PS" flashes for about 3 seconds on
the display, and then it returns to the mode which had
been obtained before the searching was performed.
This function is useful especially for calling a station with
weak signals which cannot be received by the automatic
tuning method. By only storing such a station, you can call
it any time easily.
ENTER
Flashes.
Press once.