Panasonic CF-30 Series Operating Instructions Manual page 13

2
3
2
1
3
2 Connect your computer to a power outlet.
The battery charging starts automatically.
CAUTION
Do not disconnect the AC adaptor and do not switch the wireless switch to on
until the fi rst-time operation procedure is completed.
When using the computer for the fi rst time, do not connect any peripheral device
except the battery pack and AC adaptor.
Handling the AC adaptor
Problems such as sudden voltage drops may arise during periods of thunder
and lightning. Since this could adversely affect your computer, an uninter-
ruptible power source (UPS) is highly recommended unless running from the
battery pack alone.
3 Turn on the computer.
A Pull the carrying handle forward.
B Push and hold the latch (A), and lift open the display.
C Slide and hold the power switch
power indicator lights.
CAUTION
Do not slide the power switch repeatedly.
The computer will forcibly be turned off if you slide and hold the power switch for
4 seconds or longer.
Once you turn off the computer, wait for 10 seconds or more before you turn on
the computer again.
Do not perform the following operation until the hard disk drive indicator
Connecting or disconnecting the AC adaptor
Sliding the power switch
Touching the keyboard, touch pad or touchscreen (only for model with touchscreen)
Closing the display
Turn on/off the wireless switch
When the CPU temperature is high, the computer may not start up to prevent
overheating of the CPU. Wait until the computer cools down, and then turn the
power on again. If the computer does not power on even after cooling down,
contact Panasonic Technical Support.
Any changes from the default setting of the Setup Utility must not be made until
the First-time Operation is completed.
4 <For MUI OS model>
Select OS language.
A Select OS language on "Select Language" screen and click [OK].
The language setting will start by clicking [OK] on the confi rmation screen.
You can return to the "Select Language" screen by clicking [Cancel].
The language setting will be complete in about 20 minutes.
B Click [OK] on the termination screen.
The power of the computer goes off by clicking [OK].
C Turn on the computer.
Carefully choose your language because you cannot change it later. If you
set a wrong language, you need to reinstall Windows (
5 Setup Windows.
A Follow the on-screen instructions.
After turning on the computer, "Please wait a moment while windows pre-
pares to start for the fi rst time ........." appears, and then a small circle circu-
lates on the screen. This will take a few minutes.
During setup of Windows, use the touch pad and clicking to move the cursor
and to click an item.
Do not change the settings on the screen where you select a country or re-
gion. You can set a country, region or keyboard layout in [Clock, Language,
and Region] of [Control Panel] after the Windows setup is complete.
for approximately 1 second until the
page 24).
turns off.
13