Connecting The Cabling - HP 7683 Installation Manual

Installation Guide

Connecting the cabling

Connecting the cabling
1. Connect the injector(s) to the GC. Use the tray cable, HP part number
G2614-60610, to connect the tray to the use GC. See Figure 7.
G2613A
Injector
(Back)
Injector cables
Figure 7 HP 7683 Automatic Liquid Sampler cabling
2. When the cables are connected, turn on the GC power. The tray will beep
twice. After the start-up process ends, the Ready light on the injector tower
should be on.
If the Align Mode light is on, see Turret alignment on page 16.
If either the Fault or Run light is on, see Faults on page 25.
8
G2613A
Injector
(Front)
G2614A
Tray
HP 6890 Plus GC
Tray cable