Putting The Demo Case Into Operation; Preparations; Hardware Configuration; Putting The Drives Into Operation - Siemens SIMATIC S7-1500 Manual

9 "SINAMICS V90 PN" Demo Case

9.2 Putting the demo case into operation

9.2 Putting the demo case into operation
9.2.1

Preparations


Installing TIA Portal V14

Installing HSP for SINAMICS V90 into the TIA Portal
9.2.2

Hardware configuration

Set up the hardware configuration in the TIA Portal as follows:

Insert CPU
–
S7-1515T-2 PN

Insert ET 200SP station
–
IM155-6PN HF head module
–
DI 16x24V DC ST input module
–
DQ 16x24V/0.5A ST output module
–
TM Timer DIDQ 10x24V ST technology module
–
AI 2xU ST analog input module
–
Server module to complete the ET 200SP station

Add drive
–
Links: SINAMICS V90 PN, 1AC/3AC 200-240V 2,5A/1,5A, motor 100W
–
Right: SINAMICS V90 PN, 1AC/3AC 200-240V 2,5A/1,5A, motor 100W
Note Since the two drives of the demo case are identical drives, at first, only one drive
can be added to the hardware configuration. This drive can then be put into
operation and optimized. The second drive is then created by copying from the
first drive into the hardware configuration. To do this, the copied drive only has to
be assigned a new name.
9.2.3

Putting the drives into operation

Commission the added drives as follows:

Assigning drive name: Assign PROFINET name und optionally IP address

Establish online connection to the drive
Note If the drive cannot be commissioned as desired, it is recommended to reset the
drive to factory settings and then to carry out commissioning of the drive again.
9.2.4

Optimizing drives

Optimize the speed control and the drive parameters as follows:
1. Click the tab for optimization
2. Connect online to the drive
3. Get the control priority from the drive
4. Start the automatic optimization
TOs of S7-1500(T)
Entry ID: 109743134, V1.0, 05/2017
57