■Wave output parameter setting processing program example
This example shows the program to be used when part of the parameter settings of the wave output function read from the file
register (ZR) and CSV file need to be changed. If there is no need to change the settings, this program is not required.
After the change, enable the settings using the operating condition setting request program. (Page 45 Operating
condition setting request processing program example)
(411)Sets 'CH1 Wave output start/stop request' (U0\G462) to Wave output stop request (0).
(442)Turns on the wave output setting function block start flag (M10) and changes the value of the buffer memory of the wave output function.
(605)Turns off the wave output setting function block start flag (M10).
7 OPERATION EXAMPLES
44
7.3 Program Example (for Wave Output Mode)