Mitsubishi Electric MELSEC iQ-R Series User Manual page 188

Output setting during synchronization error
Synchronization
Set whether to continue or stop the synchronization of D/A converter modules when an inter-module synchronization cycle
crossing over error (error code: 2600H) or inter-module synchronization signal error (error code: 2610H) occurs.
Setting value
0
1
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
Output setting during synchronization error
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9) to enable the setting.
■Default value
The default value is Synchronization continue (0).
Synchronization status monitor
Synchronization
The status of the inter-module synchronization (synchronization is in process or stopped) and whether the currently checked
module is the target of the inter-module synchronization function can be checked.
Monitored value
0
1
2
If the currently checked module is not the inter-module synchronization target, the monitored value is Inter-module
synchronization non-target (0).
If the currently checked module is the inter-module synchronization target and the inter-module synchronization is being
executed, the monitored value is Inter-module synchronization target (during synchronization) (2).
When an error occurs in the CPU module or the D/A converter module and the synchronization stops, the monitored value is
Inter-module synchronization target (synchronization stopped) (1).
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
Synchronization status monitor
APPX
186
Appendix 3 Buffer Memory Areas
Description
Synchronization continue
Synchronization stop
CH1 CH2
9532
Description
Inter-module synchronization non-target
Inter-module synchronization target (synchronization stopped)
Inter-module synchronization target (during synchronization)
CH1 CH2
9600
CH3 CH4
CH3 CH4