Advertisement
h
Touch
on the pattern editing screen, and set Half Cut
to ON.
• Half Cut feature is only available auto-blade holder is installed.
i
Touch the "Test" key, and cut a trial cutting pattern with
the Auto Blade (Black Holder).
j
If the backing of the template sheet is cut, adjust the Cut
Pressure(Half Cut) to lower it.
5
k
If the trial cutting of the pattern was cut properly, touch
the "Start" key and cut the rhinestone pattern.
• The rollers may leave marks in the template sheet, but this
should not affect its quality.
l
When the cutting of the rhinestone pattern is complete,
feed out the mat and peel off the template.
• Cut the template sheet along an outline slightly larger than the
pattern.
m
Place the template sheet on a flat surface with the
backing down, and then quickly peel the template sheet
off horizontally.
The template sheet cutouts remain attached to the backing.
• If all template sheet cutouts do not remain attached to the
backing, use a pointed object, such as an awl, to punch out
each rhinestone hole from the back of the template sheet.
• Do not punch out the holes from the front side, otherwise the
adhesive side may become attached to itself.
n
With the shiny side facing up, place the backing board
inside a box which is larger than the backing board or on
a larger piece of paper.
• Box is optional, not supplied.
Advertisement
