Epson L565 Service Manual page 30

L565/L566 Series
DISCHRGING INK FROM THE INK SUPPLY TANK
Discharging ink is recommended only when disconnecting the Ink Supply Tank Tube Assy from the Ink Supply
Tank. Before performing the above disconnection, discharge ink from the Ink Supply Tank as follows.
Necessary tools
• Containers (x 4) for each discharged ink
•
Injector (with a tip of
•
Clips (x 2)
•
Cotton swab (x 4)
The photos in the following procedure are for L/365/L366,L360/L362,l220/L222 Series,
but the procedure for L565/L566 Series is the same; the numbers of the tube and the
location of the Ink Supply Tank Assy in the photos are different from those of L565/L566
Series, though.
Prior to the following steps, connect the injector with the tube, and then discharge ink
according to the procedure.
Discharging preparation
1. Remove the screw (x 3) of the Guide Tube 1st and the Tube Pressing Plate .
2. Release the hook of the Guide Tube Sub , Release the Guide Tube from Dowel .
3. Release the Ink Supply Tube from rib, and release the Guide Tube 1st from the Frame Base Assy.
Tube Pressing Plate
Guide Tube ＆ Sub
4. Move the Carriage to right side .
5. Release the Joint from the rib of Guide Tube 1st .
Disassembly/Reassembly
φ
3.2 mm)
Ink Supply Tube
C.B.P. 3x10 (6.1±1 Kgfcm)
Figure 2-11. Discharging preparation (1)
Joint
Carriage
Frame Base Assy
Figure 2-12. Discharging preparation (2)
Overview
Guide Tube 1st
Rib
Ink SupplyTank
Guife Tube 1st
Revision A
Guide Tube 1st
C.B.P. 3x10 (6.1±1 Kgfcm)
Confidential
30