Advertisement
Available languages
Available languages
8. P ull the cover out of box and locate the inside sleeves. Insert the steel collar ends of these H rods
into the tops of poles F. The cover will be hanging loosely on the rod/pole assembly. Feed one H
rod through one sleeve of the cover, then
repeat with another H rod on the other side.
NOTE: You should have four H rods and one I rod.
NOTE: Flexible H rods will feel loose when
inserted. This is correct. Do not
attempt to force flexible H rods
further into poles F.
9. S lide the two remaining H rods over the previously inserted H rods. Take rod I and
insert the ends of the H rods into the steel collar ends of rod I. Pull the cover up over
the rod assembly and slide the top of the rod assembly into the large fabric pocket
inside the cover. This will require some bending of the rods.
H
Steel Collar
I
H
H
10. P ull the cab material down and back towards the arch assembly, D/C/D.
Fasten hook-and-loop straps on both sides of the D/C/D assembly. Slide
elastic loops over the rear corner of bar A on both sides. Fasten hook-and-
loop straps around all bars at various locations. (For your convenience
you may want to wait until the cab is mounted on your snow blower to
finish fastening these straps.) After the material is secured over the frame
assembly, remove bar J.
NOTE: For steps 8, 9 and 10, please be sure you wear safety glasses.
I
Steel Collar
H
H
H
H
H
H
F
F
Insert flexible rod
assembly here
D
Large Fabric Pocket
D
H
Sleeve
F
I
H
C
Back
C
A
A
Back
SAFETY GLASSES
GAFAS DE SEGURIDAD
LUNETTES DE PROTECTION
H
Front
D
Front
D
J
5
Advertisement
