Siemens DMS8000 MP4.60 Manual page 37

Building Technologies
Fire Safety & Security Products
Note: This feature is not available for MT8001
Note: Only manual pages can be used as default pages.
To associate a default page to all data points, proceed as follows:
1. Create a manual page to use as the default page.
See Creating manual pages [➙ 31] for details.
2. Select the Point Page Extension node:
<Supervisor System Settings> > MM8000 System > Logical Configuration >
Point Page Extension
3. Select the default map page in the Default page settings pane.
4. Click Set as Default button.
 The new link node appears under the page node to show the association
made. The page is now the default page for the entire set data points.
Setting the general default page
To remove the default map page:
Select the Point Page Extension node and then select Remove Default.

To associate a default page to a sub-tree, proceed as follows:
1. Create a manual page to use as the subtree default page.
See Creating manual pages [➙ 31] for details.
2. Select and extend the Graphic Maps tree to show the default page node.
3. Select the top node of the subtree (it can be a folder node).
Guide to map configuration
Creating default map pages
A6V10062441_a_en
3
37
30.06.2013