Cylinder And Piston - Husqvarna 322HD60 Workshop Manual

7.13 Cylinder and piston

7.13.1 To prepare to remove the cylinder and
piston
1. Remove the throttle handle. Refer to
install the throttle handle on page 27 .
2. Remove the fuel tank. Refer to
install the fuel tank on page 44 .
3. Remove the cutting unit. Refer to
install the cutting unit on page 30 .
4. Remove the clutch. Refer to
the clutch drum on page 32 .
Note: Do this step only if it is necessary to also
remove the crankcase.
5. Remove the starter unit. Refer to
install the starter unit on page 14 .
6. Remove the flywheel. Refer to
flywheel on page 18 .
Note: Do this step only if it is necessary to also
remove the crankcase.
7. Remove the muffler and the exhaust pipe. Refer to
To remove and install the muffler on page 17 .
8. Remove the air filter. Refer to
the air filter on page 17 .
9. Remove the air filter housing and the carburetor.
To remove and install the carburetor on
Refer to
page 23 .
The illustration shows how the product looks before you
remove the cylinder and piston.
7.13.2 To remove the cylinder and piston
1. Remove the starter unit. Refer to
install the starter unit on page 14 .
2. Remove the throttle handle. Refer to
install the throttle handle on page 27 .
1369 - 001 - 13.02.2020
To remove and
To remove and
To remove and
To remove and install
To remove and
To disassemble the
To remove and install
To remove and
To remove and
3. Remove the cutting unit. Refer to
install the cutting unit on page 30 .
4. Remove the muffler. Refer to
the muffler on page 17 .
5. Remove the carburetor. Refer to
install the carburetor on page 23 .
6. Remove the fuel tank. Refer to
install the fuel tank on page 44 .
7. Remove the flywheel. Refer to
flywheel on page 18 .
8. Remove the 4 screws, the intake manifold, and the
intake manifold gasket.
9. Remove the cylinder cover.
To remove and
To remove and install
To remove and
To remove and
To disassemble the
Repair instructions - 33