Husqvarna 123HD60 Workshop Manual page 30

4
28
Centrifugal clutch
Remove the circlip and dismantle the ball
bearings.
Check the inside diameter of the clutch
drum. If it exceeds 55,0 mm it should be
replaced.
Assemble the different components in the
reverse order as set out for dismantling.
Heat the gear housing before the ball
bearings are fi tted.
Remove the circlip holding the ball bear-
ings in place in the gear housing.
Then heat the gear housing to approx.
110°C and tap the housing against a
wooden block so that the ball bearing falls
out of the bearing seating or use a suit-
able mandrel.
Check the clutch drum for wear.
The diameter must not exceed 55,0 mm. If
this is the case replace the clutch drum.
Assemble the different components in the
reverse order as set out for dismantling.
Heat the gear housing before the ball
bearings are fi tted.