Table of Contents
Advertisement
10. Move the lever of the fuel valve to the O
the way to the right) and check for leaks. If it leaks,
replace the O-ring.
Belt Maintenance
position (all
N
Checking the Drive-Belt
Tension
Service Interval: Every 20 hours—Check the drive-belt
The drive belts should each have 1 cm (13/32 inch) of flex
when applying 6.8 kg (15 lb) of pressure, at mid-span
53).
1. Flex of 1 cm (13/32 inch)
1. Remove the divider plate; refer to
Divider Plate (page
2. Lay a straightedge along 1 drive belt, from 1 pulley to
the other
3. With your finger, push on the belt with 6.8 kg (15 lb)
of pressure, midway between the pulleys
36
tension and adjust it as necessary. Replace
the drive belts if they show any signs of
wear, cracks, glazing, or damage.
2
Figure 53
Drive Belts
2. Straightedge
Removing the
29).
(Figure
53).
(Figure
1
G019731
(Figure
53).
Advertisement
Table of Contents
