Table Of Contents; Introduction - Husqvarna W50P Operator's Manual

Introduction..................................................................... 5
Safety..............................................................................6
Assembly........................................................................ 8
Installation.......................................................................8
Operation........................................................................ 8
Product description
The product is a water pump for transportation of water.
Product overview
(Fig. 1)
1. Throttle lever
2. Choke lever
3. Fuel valve lever
4. Starter rope handle
5. ON/OFF switch
6. Oil tank cap and dipstick
7. Fuel tank cap
8. Discharge outlet
9. Water strainer
10. Air filter cover and air filter
11. Muffler
12. Pump drain cap
13. Suction inlet
14. Frame
15. Pump chamber cap
Symbols on the product
(Fig. 2) WARNING: Be careful and use the product
correctly. This product can cause serious
injury or death to the operator or others.
(Fig. 3) Read the operator's manual carefully and
make sure that you understand the
instructions before use.
(Fig. 4) Use approved hearing protection and
approved eye protection.
(Fig. 5) This product complies with the applicable
EC Directives.
(Fig. 6) Stop the engine and remove the ignition
cable before repairs or maintenance.
(Fig. 7) Risk of sparks.
(Fig. 8) Keep hands away from the rotating parts.
1421 - 004 - 09.07.2020
Contents
Maintenance................................................................... 9
Troubleshooting............................................................ 11
Transportation and storage...........................................12
Technical data.............................................................. 13
EC Declaration of Conformity....................................... 15

Introduction

Intended use
The product is used to drain or supply fresh water to and
from a location. Do not use the product for other tasks.
(Fig. 9)
(Fig. 10)
(Fig. 11)
(Fig. 12)
(Fig. 13)
Note: Other symbols/decals on the product refer to
certification requirements for other commercial areas.
Do not breathe exhaust fumes. Do not use a
combustion engine product indoors or in
areas that do not have sufficient airflow.
Risk of burn injury.
Do not smoke near fuel. Risk of fire.
Low oil level.
Noise emissions to the environment
according to European Directive 2000/14/EC
and New South Wales legislation "Protection
of the Environment Operations (Noise
Control) Regulation 2017". Noise emission
data can be found on the machine label and
in the Technical data chapter.
5