Appendix A - Lock-Out/Tag-Out Hasp Installation - Toshiba MBSWH-150-F3-KK Installation Manual

Appendix A - Lock-Out/Tag-Out Hasp Installation

The Toshiba wall-mounted MBS ships with a LOTO (Lock-Out/Tag-Out) hasp to be installed by the User in those applica-
tions requiring that capability.
Installation equipment required:
#2 Phillips Screwdriver
1. Twist the inner tongue and outer loop sections of the hasp in opposite directions, until the 0.5 mm join separates.
2. use the factory supplied hardware to mount the outer loop of the hasp on the MBS door. The two mounting holed for
the screws is located just aoe the door latch.
3. Use the factory supplied hardware to mount the inner tongue of the hasp on the inner edge of the door frame. The
mounting holes are located just above the goor latch.
4. After mounting both parts of the LOTO hasp, close th door carefully and verify the hasp loop slips over the hasp toun-
guer without interference.
5. This completed the installation of the LOTO hasp.
MBS (Wallmount) Installation - 64523-009
11