Table of Contents
Advertisement
English
2
1
S9090-43_EN_A6_CS6_0519.indd 37
4 Remove the shaving heads from the shaving
head holder.
Discard the used shaving heads immediately to
avoid mixing them with the new shaving heads.
5 Place the shaving heads in the shaving head
holder.
Note: Make sure the notches on both sides of
the shaving heads fit exactly onto the
projections in the shaving head holder.
6 Place the retaining ring holder on the retaining
1
ring (1), place it on the shaving head (2) and turn
it clockwise (3) to reattach the retaining ring.
Repeat this process for the other retaining rings.
3
- Each retaining ring has two recesses that fit
exactly into the projections of the shaving
head holder. Turn the ring clockwise until
your hear a click to indicate that the ring is
fixed.
Note: Hold the shaving head holder in your
hand when you reinsert the shaving heads and
2
reattach the retaining rings. Do not place the
shaving head holder on a surface when you do
this, as this may cause damage.
7 Attach the shaving head holder to the bottom
part of the shaving unit ('click').
37
17/05/19 18:3
Advertisement
Table of Contents
