Advertisement
Mobile Dashboard Mounting
CAUTION: The Installation Manual should be referred to for more
detailed information on warnings and safety.
To Install the Frame into the Dashboard
1. Open up the radio cut-out in the dashboard to ISO 7736 specification
(182mm x 53mm).
2. Insert the mounting frame into the cut-out and retain it by bending back the
relevant fixing tabs (using all 6 where possible). Check that the orientation of
the frame is correct by ensuring that the word 'TOP', is uppermost.
1. The tabs are easily bent back by twisting a large flat-head
NOTE
screwdriver in the slot behind the tabs.
2. For a more secure installation the frame should also be secured
with the appropriate number of screws to the mounting
conditions (minimum 1).
3. The demounting tool can be used as an aid to mounting as well as
demounting.
To Mount the Radio in the Frame (Figure 1)
1. Provide the electrical connections for the radio (power, antenna, accessories).
2. Plug in all the connectors and push the radio firmly into the mounting frame
until the two springs snap into place.
To Remove the Radio / Remote Mount from the Frame
1. Push the two demounting tools through the openings in the frame until the two
springs release the radio.
2. Slide out the radio.
1. The fixing tabs should be checked for tightness each time the radio
NOTE
is removed. The tabs are easily tightened by twisting a large
flat-head screwdriver in the slot behind the tabs.
2. The frame is not designed for regular mounting and demounting.
1
Advertisement
