Procedure
1. Secure the holding plate
⑧
bolts M5
. Use spring washers and normal washers. The tightening torque
is 5.7 Nm.
2. Secure the intermediate hinge
⑦
bolt M8x40
tightening torque is 24 Nm.
3. Secure the support
⑥
M8x40
and the nut. Use a spring washer and normal washer. The tightening
torque is 24 Nm.
4. Secure the support
5. Align the antenna. To do this loosen the threaded bolts
antenna and then tighten the threaded bolts
Antenna ANT793-8DK
A5E03484060-03, 09/2017
②
to the back of the antenna
③
and the nut. Use a spring washer and normal washer. The
④
on the intermediate hinge
④
to the wall with 4 screws via the bore holes
to the holding plate
③
⑥
und ⑦ again.
8BInstallation
①
with four threaded
②
using the threaded
using the threaded bolt
⑤
.
⑥
⑦
und
. Position the
31